Maintenance process of automatic wet towel folding and packaging machine

Purpose:

In order to ensure the safety and integrity of wet towel production equipment, find problems in time and maintain them in time, this operating procedure is formulated.

1. Scope of application:

It is applicable to the inspection of production equipment in the wet towel workshop of the company.

2. Responsibilities:

3. The equipment department is the centralized management department of this procedure;

4. The equipment department is responsible for the supervision and inspection of maintenance and repair, as well as emergency maintenance:

5. The production workshop is responsible for the supervision, inspection and implementation of the daily spot inspection and maintenance of the equipment in this procedure;

6. Team members are responsible for the production operation of this procedure.

7. Definitions

8. Safety (Health) matters.

9. The personnel shall dress correctly and the hair shall not leak out:

10. clean hands, no jewelry, long nails, no lipstick, makeup and nail polish.

11. Wash your hair, take a bath and change clothes frequently (wash your clothes once a week) to maintain personal hygiene;

12. The operator must have safety production awareness, carefully abide by the operating procedures and operate carefully;

13. The machine table is clean and tidy, and the maintenance shall be carried out regularly according to the regulations: I

14. Personnel entering and leaving the water making room must wash their hands and disinfect:

15. In case of equipment failure (or alarm), carry out relevant operations according to the contents of the fault display. If there is any doubt, it must be reported to the maintenance personnel in time. If the machine has a fault, it shall be reported for repair in time. The equipment can be put into operation only after the maintenance personnel confirm that it is normal;

16. If no one works in the workshop, stop the reverse osmosis pure water system. The offduty personnel must turn off the equipment power supply and all power supplies in the workshop, check and close the water inlet / air source valve.